It's Freezing.....is your ITHING having problems???

HOW TO UNFREEZE YOUR IPAD....

The first step to learning how to reboot or reset an iPad involves identifying the sleep/power button. When holding the iPad in portrait mode (longer in vertical direction), the sleep/power button is on the top of the device.

Next, you need to hold this button down for approximately 3 seconds. After holding the button for a few seconds, the iPad's screen will dim and you will see a red slider button that says "Slide to power off" next to it.

To reboot the iPad, slide the red button (it will have a white arrow on it) from left to right. After you have slid the button over, the iPad will begin the shut down process.

Be patient as this might take a few seconds for the iPad to properly shut down. Do not attempt to do anything else with it during this time.

If you wish to restart your iPad after resetting it, wait 10 seconds with the device off prior to turning it on. This process should eliminate whatever sluggish performance or frozen screen you were experiencing.

How to unfreeze or reset an iPod Touch

To reset iPod touch, press and hold the Sleep/Wake button and the Home button at the same time until you see the Apple logo show up on the screen:

How to unfreeze or reset an iPod Classic

1. Toggle the Hold switch on and off. (Slide it to Hold, then turn it off again.)
2. Now press and hold the Menu and Select buttons until the Apple logo appears, which may take about 6 to 10 seconds. You may need to repeat this step.

Notes:

• If you are having problems resetting the iPod, go ahead and set it on a flat surface. Then make sure the finger pressing the Select button is not touching any part of the click wheel. Also be sure that you are pressing the Menu button towards the outside of the click wheel, not near the center.
• If the above mentioned steps do not work, then you can try connecting your iPod to a power adapter and plug the power adapter into an electrical outlet, or connect the iPod to your computer. Make sure the computer is turned on and isn’t set to go to sleep.

How to reset an iPod Nano (1st, 2nd, and 3rd Generation)

This one is similar to how you would do it for an iPod Classic:
1. Toggle the Hold switch on and off. (Slide it to Hold, then turn it off again.)
2. Now press and hold the Menu and Select buttons until the Apple logo appears, which may take about 6 to 10 seconds. You may need to repeat this step.
You can also reset an iPod Mini in the same way as the above steps.

How to reset or unfreeze an iPod Shuffle

1. First , eject your iPod shuffle from iTunes, if you have it connected.
2. Then remove the iPod shuffle from the USB dock.
3. Move the switch that is on the top of the iPod shuffle to the off position.

Note: When iPod shuffle is off, the green stripe by the switch is not visible.
4. Wait 5 seconds.
5. Move the switch back to the on position so green stripe will be visible in either position.
And that’s it! Hopefully, now that you know these steps, you don’t have to keep taking out the battery to unfreeze your iPod! Any comments or questions, make sure to write below! Enjoy! Source: Apple Support